Price : Too low to display
SABRENT SBT-SRD4 Silicon Image RAID Native Serial ATA (SATA-150) 4 Ports PCI Controller Host Card Adapter Add 4 Serial ATA Ports to your desktop! Add Reliable Proven 1,500Mbps of Serial ATA 4 Ports and RAID 0, RAID 1, RAID 0+1, RAID 1+S(Mirrored-Sparing) to your system This PCI Host Adapter can upgrade your desktop computer to have four Serial ATA RAID Channels. RAID 0 (Striping), RAID 1 (Mirroring), RAID 0+1 (mirrored-stripping) and RAID 1+S (Mirrored-Sparing) improve the data performance and provide the data redundancy and rebuilding. Specifications: Provides 2 Brackets to Support Low profile PCI and Regular size PCI in one card 48 bits LBA can Break Capacity-Limit to Support HDD larger than 137GB Four high speed Serial ATA interface ports, each supporting 1st generation Serial ATA data rates 1.5Gb/s Hot-plug capability Fully compliant with Serial ATA 1.5G specifications Provides RAID 0 (Stripping) to greatly increase the performance of data transfer by simultaneously writing data to 2 drives Provides RAID 1 (Mirroring) to protect the data from a disk failure by writing identical data on 2 drives RAID 0+1 (Mirrored-Stripping) combine both Striping and Mirroring technologies to provide both the performance enhancements that come from Striping and the data availability and integrity that comes from Mirroring RAID 1+S (Mirrored-sparing) can automatically replace the failed drive and rebuild the system when booting HDD is failed Supports ATAPI commands Supports Spread Spectrum in receiver Independent 256-byte FIFOs (32 bit * 64 deep) per Serial ATA channel for host reads and writes Compliant with PCI Specification, revision 2.2 Integrated PCI DMA engines Four Pin header on board for LED connection 32 bit, 33/66MHz fully compliant PCI host interface Supports Windows 98, Windows Millennium, Windows NT 4.0, Windows 2000, XP, 2003 and Linux, Novell Netware Acts as NON-RAID when not BIOS configured RAID
This review is from : Sabrent SBT-SRD4 Silicon Image RAID Native Serial ATA 4 Ports PCI Controller Host Card Adapter
Old Firmware doesn't support Seagate 1TB . I bought this controller to support a single new Seagate 7200.11 1TB SATA drive.
I had no intention of using it in a RAID configuration.
As delivered the card would not recognise the drive and my
PC would not boot, hanging at the SATA disk detection screen.
This card comes with some pretty old Silicon Image firmware.
Googling I discovered that there is much newer firmware available
from SII. I downloaded the current non-RAID firmware from SII
but it wouldn't install from win XP. I finally managed to install
the new firmware by setting up a USB stick to boot the PC into
FreeDOS, then flashing the new firmware from DOS.
The card now detects the Seagate drive and works correctly
except for one issue: If I cold-boot the PC with a reset or power
cycle all is well, but if I issue a re-start from winXP the card
will still hang at the disk detect screen. This is only a minor
annoyance, however.
Overall the card is cheap and it does work but only when upgraded
to current firmware.
Old Firmware doesn't support Seagate 1TB . I bought this controller to support a single new Seagate 7200.11 1TB SATA drive.
I had no intention of using it in a RAID configuration.
As delivered the card would not recognise the drive and my
PC would not boot, hanging at the SATA disk detection screen.
This card comes with some pretty old Silicon Image firmware.
Googling I discovered that there is much newer firmware available
from SII. I downloaded the current non-RAID firmware from SII
but it wouldn't install from win XP. I finally managed to install
the new firmware by setting up a USB stick to boot the PC into
FreeDOS, then flashing the new firmware from DOS.
The card now detects the Seagate drive and works correctly
except for one issue: If I cold-boot the PC with a reset or power
cycle all is well, but if I issue a re-start from winXP the card
will still hang at the disk detect screen. This is only a minor
annoyance, however.
Overall the card is cheap and it does work but only when upgraded
to current firmware.
Sabrent SBT-SRD4 Silicon Image RAID Native Serial ATA 4 Ports PCI Controller Host Card Adapter Reviews
No hassle installation with seamless operation . Thanks to the simple, no conflict operation of these Serial ATA PCI Controllers, I now run 10, 500 GB hard drives in my server, with all exhibiting excellent performance and no problems to date. I would recommend these to anyone requiring RAID configurations or massive storage needs. Kudos!
No hassle installation with seamless operation . Thanks to the simple, no conflict operation of these Serial ATA PCI Controllers, I now run 10, 500 GB hard drives in my server, with all exhibiting excellent performance and no problems to date. I would recommend these to anyone requiring RAID configurations or massive storage needs. Kudos!
Sabrent SBT-SRD4 Silicon Image RAID Native Serial ATA 4 Ports PCI Controller Host Card Adapter Opinions
Good little card . Installed the card in a home-built Freenas box, then tried to find an update to the on-board firmware at Silicon Graphics - Couldn't find one that worked in Windows or DOS. None of the choices from the text menus seemed to match the actual board type. Pressed on despite the lack of update, and Freenas recognized the drives just fine. I setup a software Z-Raid array of 4 drives with no problems. (To avoid the usual problems with software Raid arrays, my boot drive was a more reliable CF IDE drive)
.
The card has worked with no problems for the past month - I have fiddled with my array a few times and even rebuilt the array once as an experiment to see what a future disk failure would look like. As long as you are aware of the disk-size limitations, this is a VERY affordable raid card for old Sata Drives under 500GB.
Good little card . Installed the card in a home-built Freenas box, then tried to find an update to the on-board firmware at Silicon Graphics - Couldn't find one that worked in Windows or DOS. None of the choices from the text menus seemed to match the actual board type. Pressed on despite the lack of update, and Freenas recognized the drives just fine. I setup a software Z-Raid array of 4 drives with no problems. (To avoid the usual problems with software Raid arrays, my boot drive was a more reliable CF IDE drive)
.
The card has worked with no problems for the past month - I have fiddled with my array a few times and even rebuilt the array once as an experiment to see what a future disk failure would look like. As long as you are aware of the disk-size limitations, this is a VERY affordable raid card for old Sata Drives under 500GB.
Works with linux. Does not work with WHS(Windows Home Server) . As described this product does the job. If you are going to install windows home server on the drives connected with this raid card you will need to dig around for alternative drivers because the drivers that come with it do not work. Works perfectly with Linux (Ubuntu Server, Freenas, etc.)
Speed is probably going to be limited by your PCI bus. Had no complaints with speed with disks arranged w/ RAID or w/o RAID. If you putting this in headless unit detecting RAID failure will be extremely difficult.
Speed is probably going to be limited by your PCI bus. Had no complaints with speed with disks arranged w/ RAID or w/o RAID. If you putting this in headless unit detecting RAID failure will be extremely difficult.
FAST SHIPPING . I DID RECIEVE MY ITEM ON TIME AND WAS IN EXCELLENT CONDITION THANK YOU VERY MUCH
Cons Review
Does not work with Linux . Linux support is listed, but could not make work on my system (Fedora 10 x86_64). The driver cd was a mess (disorganized), and targeted at building support into a 2.4 kernel. My 2.6 kernel has module support for the chipset on the card (Silicon Image 2114), but got no signs that the card was even connected. Returned.
waste of money . Useless, does not work, no manual, not even a "README" on the cd, card looks used, too expensive to ship it back. I'll just keep the cables
Does not work with Vista SP1 . This product is not recognized as being installed. Installed both the Sabrent and Syba drivers... and nothing. Even had the card replaced and still nothing. Simply was not detected by the system.
Hair puller . Windows sees card fine but drivers wont install have surfed the internet trying to find drivers that work waste of money and to expensive to ship back no more amazon for where do i cancel.
Related Post
- StarTech.com 4 Port CardBus Laptop USB 2.0 PC Card Adapter (CB420USB)
- Psion 56k Travel Modem
- AVerMedia MTVUHDDVR Avertv HD USB Digital Video Recorder
Product Details
EAN : 0188218000088UPC : 188218000088
MPN : SBT-SRD4
Brand : Sabrent
Weight : 1 pounds
Height : 2 inches
Length : 7 inches
Width : 6 inches
Binding : Personal Computers
Manufacturer : Samsung
Model : SBT-SRD4
Publisher : Samsung
SKU : INGU0012
Studio : Samsung
Where To Buy
You can buy Sabrent SBT-SRD4 Silicon Image RAID Native Serial ATA 4 Ports PCI Controller Host Card Adapter on Amazon . Click here to Read More
