Thursday, September 8, 2011

Syba SD-EXPC34-1S2 JMB Chipset 1x e-SATA Ports, 34mm, Up to 3.0Gb/s ExpressCard


Price : Too low to display
BUY NOW
ExpressCard JMB Chipset 1x e-SATA Ports, 34mm, Up to 3.0Gb/s

This review is from : Syba SD-EXPC34-1S2 JMB Chipset 1x e-SATA Ports, 34mm, Up to 3.0Gb/s ExpressCard
Works perfectly with Macbool Pro . This ExpressCard works perfectly with my old 2.16 GHz MBP and my husband's new 2.6 GHz model, with any of our four eSATA enclosures, 2.5" and 3.5". No drivers needed, no problems. Cost less than half the price of my FirmTek Seritek ExpressCard, which has required two firmware updates to work properly. Based on two months of use I highly recommend this card.
Syba SD-EXPC34-1S2 JMB Chipset 1x e-SATA Ports, 34mm, Up to 3.0Gb/s ExpressCard Reviews
Worked fine . Product worked as advertised on my MacBook pro without the need to install any additional software. My only gripe is that after backing up my system, (3 hours use), the sticker label on the card began peeling. I just pulled the sticker off, but testing adhesive against heat output should be a no brainer.
Syba SD-EXPC34-1S2 JMB Chipset 1x e-SATA Ports, 34mm, Up to 3.0Gb/s ExpressCard Opinions
Works fine with a Mac not so well with XP via Parallels . The card works fine with my Macbook Pro. Just plug and go. The transfer speed is incredible and everything I was hoping for. It is a shame Apple is dropping ExpressCard slots from the 15-inch notebooks.

The two downsides to this particular card are that it is too easy to dislodge the ESATA cable from the card, and the card itself doesn't 'latch' into the notebook very well. But it's easy to work around this: just don't move things around while the card is in use.

Worth a note: I was never able to get this card to work with Windows XP running on Parallels on the same Macbook Pro. Windows never sees the card even with the driver installed. This is most likely an issue with the emulation and not the fault of the card. I have not had a chance to try it with XP via VMware Fusion.

Great IF you need the interface. . I bought this for my old PC which did not have an eSATA port. IF you, too, need this card for an eSATA external drive, but are thinking about just using a USB connection instead, BUY THIS CARD. My speed tests between my PC and my Cavalry Storage CADA-SA2 Series 2 TB USB / eSATA 2-bay RAID Personal Disk Array CADA002SA2 - Includes eSATA Kit proved that transferring files WAS 18 TIMES FASTER WITH THIS CARD THAN WITH A USB CONNECTION.
Works Well . This drive allowed me plug in an eSATA drive and boot from a mac partition without issue. I was careful with the hardware and it never froze my computer.

Cons Review
Doesn't work on Vista be warned . Several problems with this, ended up returning it:
*Would not install correctly. The drivers on the CD included didn't install at all and the drivers on the website didn't work.
*Poor instructions. The tiny little instruction sheet, which only includes Windows instructions, referred to non-existent files and folders on the CD, which seems to include drivers for every product made by the company, not just this one.
*Caused other problems. After trying to install it, my PC wouldn't shutdown or boot properly until I rebooted into safe mode (after having to turn off the power to get it to shut down) and running system restore to undo the driver install attempts.
*Poor customer service. Before returning it, I emailed the company. I received one reply telling me to do things I had already tried several times, then they never replied to my second email.
Not for Vista/7 . Is not reliable for any sustained work in Vista (32 up-to-date), and Win 7 (32 and 64 up-to-date). I wanted this to work and gave it more than several hours of trials. Installed various versions of JMB36X driver from JMicron site (a trip in itself). Had partial successes occasionally when following just the right sequence on install, turn off, reboot, turn on, etc. The right sequence? Not sure, seemed variable. Occasionally got as far as reading and writing folders and files to eSATA-ed drives (NTFS). ALWAYS got to a point where reading/writing became endlessly long and finally failed, usually disabling the device until re-installed.

Consigning this device to the trash bin and buying one that uses Silicon Image chip, SIL3132.
Best Connectivity isn't the best . I bought this eSATA express card adapter for connecting an external hard drive to my Toshiba L305-S5909 laptop. I bought a new Gforce Megadisk 1TB Fantom drive with triple USB-2, Firewire, eSATA interface support. The Fantom drive worked on eSATA with my desktop computer which has a native eSATA port. The Fantom drive worked on my Toshiba laptop, running with Vista-64 via the USB-2 interface, but using the Best Connectivity Syba SD-EXPC34-152 JMB Chipset 1x eSATA adapter, nothing I could do would cause the Toshiba to recognize the Fantom drive. I have an Iomega external hard drive for my other Windows XP desktop computer, and the Syba adapter did allow my Toshiba to recognize the Iomega drive.

I was about to return the Fantom drive, but before I did, I bought a DX-ESATL Dynex 2-port eSATA II ExpressCard Adapter. This adapter came with a mini-CD to install the correct driver. I installed it on my Toshiba, and connected my Fantom drive to the Toshiba, and everything works perfectly.

So the Syba unit seems to have a less robust interface, at least for a Vista-64 machine.
You Get What You Pay For... . I bought this product a few months ago and it worked perfectly out of the box and was recognized immediately by my MacBook Pro. I noticed; however, as time wore on the speed of the transfers slowly dropped and eventually the hard drive that was connected to this card would no longer mount. Thinking it was the drive, I tried repairing it using Disk Utility which came back with a clean bill of health. So then I proceeded to use a FW800 cord instead and instantly the drive was mounted and accessible from the MBP. It's clear, the quality control and durability of these cards is lacking and, despite the low price, I wouldn't recommend purchasing this item if you plan on eSata frequently.
Doesn't work with MacBook Pro and Western Digital 500GB My Book . Didn't work form the start. Three quarters of the times wasn't able to mount the drive. When it was mounting the drive, it was hanging files transfer in between with consequent system hang and forced restart. The Western Digital 500GB My Book works fine when using FireWire 400. For fairness, I haven't tried the card with any other drive.


Feature Syba SD-EXPC34-1S2 JMB Chipset 1x e-SATA Ports, 34mm, Up to 3.0Gb/s ExpressCard

  • Best Connectivity SATA II ExpressCard/34 General Features: JMicron JMB360 chipset
  • Compliant with ExpressCard interface Compatible to 1x Lane PCI Express throughput
  • Support SATA II specification with transfer rate up to 3Gb/s
  • Backward compatible to SATA 1.0a specification eSATA compatible for all external ports
  • Support hard disks with Native Command Queue (NCQ) feature




Related Post

Product Details

EAN : 0810154013463
UPC : 810154013463
MPN : SD-EXPC34-1S2
Brand : Syba
Weight : 1 pounds
Height : 1 inches
Length : 7 inches
Width : 7 inches
Binding : Personal Computers
Manufacturer : Syba
Model : SD-EXPC34-1S2
Publisher : Syba
SKU : A115332
Studio : Syba

Where To Buy


You can buy Syba SD-EXPC34-1S2 JMB Chipset 1x e-SATA Ports, 34mm, Up to 3.0Gb/s ExpressCard on Amazon . Click here to Read More